Xylem IM174 R00 Instructions for changing a grinder pump Bedienungsanleitung PDF herunterladen

Instructions for changing a grinder pump cutter / cutter ring.

IM174R00

30°

60°

90°

120°

150°

NO SHIM

.005”

.010”

.015”

.020”

1. Thread impeller onto motor shaft and hand tighten holding the shaft with

screwdriver.

2. Thread cutter onto shaft and seat on impeller – do not tighten.

3. Check for alignment of the cutter to the impeller (per Picture).

Remove cutter and shim as necessary to align cutter blades with impeller

vanes (per Table and/or Template). Use screwdriver to hold shaft and

tighten cutter by tapping with plastic hammer.

4. Place casing on bearing housing and locate discharge opposite cord set

entry, secure w/ cap screws.

5. Check cutter to cutter ring clearance using .002” shim stock.

Adjust casing position with plastic hammer to ensure cutter

rotates freely. as ALIGN

6. Run dry for 10 seconds and recheck cutter to cutter ring clearance as

performed above.

SHIM

ANGLE OFFSET

(DEG.)

SHIM THICKNESS

(IN.)

0 - 30°

NO SHIM

BLUE

30 - 60°

.005”

BROWN

60 - 90°

.010”

PINK

90 - 120°

.015”

YELLOW

120 - 150°

.020”

IM174R00 1

Inhaltsverzeichnis

Seite 1 - IM174R00

Instructions for changing a grinder pump cutter / cutter ring. IM174R00 0 30° 60° 90° 120° 150° NO SHIM .005” .010” .015” .020” 1. Thread impe

Kommentare zu diesen Handbüchern

Keine Kommentare

Xylem IM174 R00 Instructions for changing a grinder pump Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Pumpen Xylem IM174 R00 Instructions for changing a grinder pump herunter. Xylem IM174 R00 Instructions for changing a grinder pump cutter / cutter ring User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Pumpen Xylem IM174 R00 Instructions for changing a grinder pump