Xylem IMS ABII 1 Aquavar ABII Quick Start Guide Bedienungsanleitung PDF herunterladen

Aquavar ABII Quick Start Guide

Installation Steps:

1. Install the Pump

• Plumb suction and discharge of pump into piping.

• Install a check valve on the suction side.

• Locate the pump as near liquid source as possible.

2. Install the Pressure Transducer

• Install the pressure transducer in the tank tee provided with the unit.

• Locate the transducer within 120” of the controller.

3. Mount the Controller

• Mount vertically in a well ventilated, shaded area with 8 inches of free air

space on every side and temperature between 34º F and 104º F.

4. Connect Input Power

• Connect the 1Ø power from a 20 amp 2-pole circuit breaker.

• Do not use GFCI protection with ABII as nuisance tripping will result.

5. Output Power Connections

• Connect the output power leads from the controller to the 3 motor leads

in the conduit box on the motor.

6. Set the motor Overload Switches (or dials, 3 and 5 HP)

• Complete systems have overloads pre-set at factory.

7. Set the Pressure - Factory pre-set is 50 PSI

• Push and Hold the Increase or Decrease Pressure Adjust Pushbutton

until the desired pressure setting is reached.

• The maximum allowable pressure setting is 85 psi.

8. Set the Application Switches (or dials, 3 and 5 HP)

• Minimum Speed of 10 Hz – the incoming pressure is within 20 PSI of the

desired pressure setting.

• Minimum Speed of 30 Hz – the incoming pressure is 20 PSI or more below

the desired pressure, if pumping from a tank or if drawing a suction lift.

• Ramp Speed – Slow - Low ow; Medium - Medium ow; Fast - High ow

QUICK START GUIDE

IMS-ABII-1

1 2 3 4

Inhaltsverzeichnis

Seite 1 - QUICK START GUIDE

Aquavar ABII Quick Start GuideInstallation Steps:1. Install the Pump• Plumb suction and discharge of pump into piping.• Install a check valve on the s

Seite 2 - Typical Installation

Aquavar ABII Controller Typical InstallationThis diagram shows a set-up for municipal water connection. This allows pump maintenance without main line

Seite 3 - Quick Start Up Guide

Aquavar ABII Quick Start Up GuideLABELS FOUND ON THE CONTROLLER ACCESS COVER: Fault CodesMotor Overload SettingWARNING: Disconnect Power And Wait For

Seite 4 - Aquavar ABII Wiring Diagram

Input230V1 PhaseGNDL1L2 (N)See Manual ForSwitch SettingsApplic.TypeOutputTo Motor1 2 3 4 1 2 3 4PressureTransducerInput (Wht)+5V (Red)Com. (Blk)T1T2T3

Kommentare zu diesen Handbüchern

Keine Kommentare

Xylem IMS ABII 1 Aquavar ABII Quick Start Guide Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Pumpen Xylem IMS ABII 1 Aquavar ABII Quick Start Guide herunter. Xylem IMS ABII 1 Aquavar ABII Quick Start Guide User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Pumpen Xylem IMS ABII 1 Aquavar ABII Quick Start Guide