Xylem O&M Mini F Series Variable Speed Bedienungsanleitung PDF herunterladen

Operating and Maintenance Instructions

Declaration of conformity

Lowara pumps UK declare that the Mini F Booster set conforms to the requirements of the Machinery Safety

Directive 98/37/EEC.

Conforming to the UK Health & Safety Requirements S.I. 1992 No 3073 S.I. 1994 No 2063

Water supply (Water fittings) regulations 1999

Simple pressure vessel directive 87/404/EEC

Signed: Position: Engineering manager Date: 27-02-2012 Revision

Clive Willmott

Introduction

This leaflet contains information to enable the safe installation and operation of the products mentioned.

The following instructions must be read and understood by all persons responsible for the installation,

operation and maintenance of this product.

Warning Symbols

Safety instructions where noncompliance would affect safety.

Safety instruction where electrical hazard is involved.

Safety instruction where noncompliance could cause damage to the equipment.

Instruction for safe us

This product has been designed for boosting cold water in potable water installations to the

operating conditions shown.

This product should not be installed until this leaflet has been studied carefully and understood.

Handling, transportation and installation of this equipment should only take place with the proper

use of lifting equipment. This product must be stored in a frost-free dry environment.

Noise Emission

This equipment operates at a noise level lower than 70dBA.

Operating limits

Fluid temperature 0°C to 40°C

Ambient temperature 0°C to 40°C

Operating pressure Max 5Bar.

Protection class. Motor & Electrical panel IP55

Mini F 1-2 Pump Cold Water

Booster Sets Fixed Speed

mini f booster set o and m instructions:Layout 1 09/05/2012 15:37 Page 1

1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - Booster Sets Fixed Speed

Operating and Maintenance InstructionsDeclaration of conformityLowara pumps UK declare that the Mini F Booster set conforms to the requirements of the

Seite 2

InstallationThe cold Water booster set is despatched mounted on a wooden pallet and covered in a protective film, it isrecommended that the unit be re

Seite 3 - Pump 1

Discharge pipe workOn two pump sets the discharge pipe work can be connected to either end of the booster set, ensure theblanking cap is fitted to the

Seite 4 - Fig 3

Fig 2 4OperationThe booster set is designed to boost the system pressure and maintain sufficient pressure to overcome thestatic height and frictio

Seite 5 - Fault Possible Cause Remedy

CautionThis booster set is an automatic machine; the pumps may start up automatically withoutprior warning.The set contains pressurised water; reduce

Seite 6 - Lowara UK Limited

6DisposalDisposal of this product should be carried out in accordance of local codes and regulation pertaining to thedisposal of waste, including pack