Xylem STORM 3 UPGRADE Bedienungsanleitung PDF herunterladen

UPGRADE TO STORM

INSTALLATION INSTRUCTIONS

Take a picture of the inside of your enclosure

for reference, put on your anti-static wristband

and attach the clip to the ground lug located

on the bottom of the EcoNet enclosure.

The ground lug should already be wired to

a ground rod, which is buried in the ground.

Bottom of Enclosure

Green Connectors

What You Need

Required Quantity

Storm 3 Data Logger 1

Mounting plate 1

Phillips screwdriver that is 9.5” long 1

Small ﬂat blade screw driver (2mm wide blade) 1

Adjustable wrench 1

Laptop / Smart Phone / Tablet with Wi-Fi 1

Storm Central Registration ID 1

Suggested Quantity

Safety glasses 1

White electrical tape 1

Pen 1

Anti-static wristband 1

Camera or notepad 1

Digital multimeter 1

*Activate your stormcentral.waterlog.com account and log in prior to going out to your

equipment site. Contact WaterLOG Technical Support at 435.227.1767 for further ques-

tions, and to obtain access to the Storm Central Service. Refer to the ‘Storm Central Getting

Started Guide’ for detailed instruction on set up with Storm Central.

Remove the three green ﬁve position

connectors from the side of the EcoNet.

Remove and label the individual wires as

A-F, from the green ﬁve position Phoenix

connectors:

To avoid short circuits, cover the wire

ends with electrical tape until it is time for

reconnection in Storm 3 connectors.

Connector 1

A. GND black wire from 4th position of 1st connetor.

B. SDI-12 purple wire from 5th position of 1st connector.

Connector 2

C. GND green wire from 3rd position of 2nd connector

D. GND black wire from 4th position of 2nd connector

E. VBATT red wire from 5th position of 2nd connector

Connector 3

F. +12V Out red wire from 5th position of 3rd connector

Anti-static wrist band

1 2 3 4

Inhaltsverzeichnis

Seite 1 - UPGRADE TO STORM

UPGRADE TO STORMINSTALLATION INSTRUCTIONSTake a picture of the inside of your enclosure for reference, put on your anti-static wristband and attach th

Seite 2

Disconnect the black antenna cable from the bottom of the EcoNet unit. Use wrench to loosen if needed.Using a 9.5” Philips head screwdriver, unscrew f

Seite 3

Insert wireless adaptor into a USB port and wait until the active light starts blinking. Connect to the Storm 3 Wi-Fi network, via PC / Smart Phone /

Seite 4 - Tel: (435) 753-2212

Make sure the Site ID is set. Start collecting data by selecting “Enabled” from the “Scanning” drop down box on the home screen.Go to the “Data” scree

Kommentare zu diesen Handbüchern

Keine Kommentare

Xylem STORM 3 UPGRADE Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Ausrüstung Xylem STORM 3 UPGRADE herunter. Xylem STORM 3 UPGRADE User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Xylem STORM 3 UPGRADE